FDM Printed Low-Profile Key Stems

Notes on FDM printed key stems

FDM Printed Key Stem Prototypes #

day 2 just tried printing the stems sideways with pretty good initial results.

issues:

  • elephant’s foot on front surface
  • overthick plus & spring stem from drooping

changes for next revision:

  • chamfer bottom edges to avoid elephant’s foot
    • 0.5 mm
  • shorter plus segment facing down
    • 0.5 mm
  • remove bottom half mil from circle of stem spring rod
    • 0.5 mm

fits quite well issues:

  • sag on plus & spring stem required trimming

changes for next revision:

  • remove internal fillet on spring stem
  • add taper to spring stem
  • add taper to bottom plus face

tapers failed without support so going to return to supported printing and remove tapers.

changes for next revision:

  • support whole bottom plus surface and tips of higher
  • add second nearer support on spring stem
  • reduce layer height to 0.1

this worked great. issues:

  • required filing on leaf contact surfaces
  • support difficult to remove
  • lots of stringing
    • used heat gun to remove, worked well
  • noticed stem was quite wobbly compared to injection molded part

changes for next revision:

  • going to squat v1. this should lower key height by 1.5 mm, and key travel, but keep actuation distance at 2mm
  • inset 6mm circle for keycap stem to sink into
  • lower plus by 1.5mm
  • lower spring stem top surface by 1.5 mm as well
  • reduce support coverage to half of plus stem, and just the tip of the spring stem
  • reduced sled/rails corner radius to 0.3 mm from 0.4 in the hopes of reducing slop

this was a solid success but it really didn’t lower the height of the keys at all.

changes for next revision:

  • lower plus and circle by an additional 2mm
  • lower spring stem top surface by 2 as well
    • this required removing the spring inset section
  • added 0.5mm chamfer between inside face and rail walls

this had some success. This lowered them to a good spot but now the keycaps butt up against the top surface of the housing before the key can actuate. also the legs are hooking over the top of the leaf because they curl up while printing and this is creating some difficulty for assembly. it is time to start lightly modifying the legs’ placement and possibly their geometry as well. the spring stem might also be a little long now.

changes for next revision:

  • lower legs by 1 mm
  • raise heigh of right leg undercut by 1 mm to compensate for lowering
  • cut 1mm off of spring stem to avoid bottoming out
  • add heavy chamfer to spring stem end to compensate for swelling in print
    • .6mm
  • cut end off of legs & round the sharp edge to reduce catching on leaf during instal
    • removed 0.75 mm from the ends, and added 0.4mm fillet

This worked great. Key now has a 1mm actuation point and works consistantly while being several mm lower.

issues:

  • sloppy loose fit in rails including not sitting flat

…